Facility relocation vs. expansion: reading a named account's footprint change

You pull up the latest pass on a named account's main facility and something's different. New grading at the back of the lot, a slab poured, maybe a whole second building taking shape. Before you draft the outbound email calling it a capex signal, it's worth fifteen minutes to make sure you're not watching a move.
Relocation and expansion look nearly identical in a single frame. Both show new construction going up. The tell is the rest of the footprint: whether the existing building keeps running while the new pad goes in, or starts going quiet.
Check what's happening to the old site
The fastest way to split the two: does the existing facility stay loaded, or does it start going quiet?
An expansion usually leaves the original building running at full tilt. Parking stays full, dock traffic keeps moving, and whatever's stacked in the yard stays put while the new pad gets built out alongside it. The company is adding capacity, not swapping it.
A relocation does the opposite. Watch two or three monthly passes in a row: parking thinning, trailer traffic dropping off, outdoor storage getting cleared out, a lease sign showing up near the entrance. If the original site is winding down while a new one spins up somewhere else, that's a move, and the account's total footprint might not be growing at all. It could be shrinking, if the new building is smaller than the one they're leaving.
Compare both footprints, not just the new one
Size is the second check. Rough out the square footage on both sites, old and new.
If the new building lands close to the size of the one going dark, call it a like-for-like swap. Companies do this over lease expirations or because the old building needs too much work, not because they're scaling. That's not a trigger worth a note to your AE on its own.
If the new pad is meaningfully bigger than what's being vacated, or the old site stays fully active while the new one is additive square footage on top of it, that's expansion. Headcount, equipment spend, or a production line is usually coming with it.
Distance is the other half of this check. A new pad poured on the same parcel, or on the adjacent lot in the same industrial park, reads as expansion almost every time. A new building forty miles away near a different highway interchange reads as relocation, even before the old site has fully gone dark. Some companies run both locations for a few months during the handoff before closing out the original address for good.
Use permits and listings as the tiebreaker
When the imagery alone doesn't settle it, the paper trail usually does. A permit filed as an addition or alteration at the existing address points to expansion. A new building permit at a new address, paired with a commercial listing on the old one, points to relocation. Neither shows up the day the first footings go in, which is exactly why they're a lagging check rather than the trigger itself.
A single snapshot won't give you any of this. One look at new construction can't show whether the old site is emptying out behind it. You need the sequence, the same site tracked across several months, so the pattern of what's growing and what's going quiet shows up on its own instead of you guessing off one picture.
That's the gap a monthly footprint feed on named accounts closes: a new pad gets flagged the month it first appears, tied to a location and a rough size, with the account's other sites tracked alongside it so the relocation-versus-expansion call is already half made before permits catch up. Capex Signals tracks named-account sites every month for exactly that kind of read.
If your territory has an account doing this right now, run it through Capex Signals before you write the trigger note.